Vehicle Wrapping >>

How much does custom car wrapping cost?

There is no set price structure on how much a vehicle wrap costs.
Vehicle wraps are priced per square metre of material used and the complexity of the application.
i.e. complex difficult to fit installations will take much longer than flat and gentle curved body contours.
Cars also vary greatly in size. There for wrapping the likes of a Mini-cooper would use less vinyl than the likes of a BMW estate car.

What part of my car can I get wrapped?
Almost any part of your car which has a high “Gloss” finish can be wrapped.
However, there are limitations on deep, sharp recesses or odd shaped body parts. This is not a limitation to our ability to apply, this is a limitation of the film.

What colour of Carbon Fibre can I have?
Carbon fibre wrapping film comes in a limited range of colours. The colours we offer are Black, Brown, White, Silver and Gun Metal Silver.

What colours do the solid colour change films come in?
There are around 40 different solid colour wrapping films available. These include some metallics and also Matt finish films.

Is Carbon Fibre wrapping film more expensive to have than a solid colour wrapping film?
Yes, even though solid colour change film application time is similar to Carbon Fibre. Carbon Fibre is a more expensive film.

What about Obsticles on my Vehicle, can these be wrapped over?
To help maximise the finish of your wrap and lower the installation time, we advise our customers to arrange to have as many obsticles as possible professionally removed from their vehicle. Obsticles such as Door Mirrors, Window wash nozzles on the vehicle bonnet, plastic door mouldings, door handles, side wing indicators, roof arial fitment, boot spoiler.

If you cannot arrange for these to be removed, we can, and often do still apply the wrap. However, depending on how large or the position of the obsticles. releif cuts "sometimes" have to be made in the film to allow the vinyl to be applied over / around.
e.g. It is impossible to apply wrap film over a door hand and in the recessessed area below the handle. there for, removing the handle allows the vinyl to be applied into the handles recessed section seamlessly. we will then apply a seperate peacie of vinyl over the handle itself, should it be required.

It is also important that we minimise any cuts that may need to be made on the vehicle as a result of obsticles.

Do i need to clean my car prior to arrival?
Yes, it is important the cars exterior is as clean as possible prior to arrival.

The car has to be completely dry also before we can begin working on it. so it is best to take it to a car wash at least an hour before arrival to allow it to dry off.
Do NOT wax or polish the vehicle, as this can contribute to failure of the vinyl adhereing to the vehicle body.
We will clean the full car down with Isopropynol alchohol to make sure there is no residue grime, lecquer or polish.